Feature Request - New property to indicate monitoring is disabled
I have a problem where my users will disable alertingon a resource that has been removed from the environment instead of deleting it. Or they may disable alerting and forget to re-enable it. With alerting disabled, my no-data datapoint alerts never trigger. In the case of removed devices, the resources just hang out there forever andnever getremoved because theydon’t show up on my data collection failures dashboard. Devices for which the user intended to re-enable alerting eventually meet the same fate unless they go down and we don’t know about it. Either of these outcomes is bad news. It would be nice if there were a property which would indicate that alerting for aresource has been disabled. As far as I am aware, there is currently no way to do this. Then I couldcreate a dynamic group of devices which have monitoring disabled. As devices are populated in the group, I can investigate them. As it stands now, I have to go manually hunt them down.
Netflow Alerting Rules
Not only restricting you to visualising the Netflow data on LM Platform. Interestingly, the most recent improvement to LogicMonitor Netflow is the Traffic Alerting Rules. It is possible to set up traffic alert rules for the NetFlow resources to get alerts when a resource's traffic hits a specific threshold, drops off for a specified length of time, etc. Traffic Alerting Rules feature are available and you can create rules at: Traffic Alert Rule at Group Level Traffic Alert Rule at Resource Level Don't missout on the advantages of this feature and refer the below link for more details. https://www.logicmonitor.com/support/traffic-alert-ruleFeature Request - Alerting Protection Prompt
I would like to submit a recommendation for a feature request please. This would benefit a lot off users I believe. I work for a large managed service provider with many customers in LM. While checking my customers today I noticed the top level resource grouping for one of them had Alerting switched OFF. I asked an LM Admin to check who had set this and when to discover after further investigation an engineer had mistakenly clicked this 5 days ago. Given how easy this click to alter status and the potential impact it has is, I recommend if this is altered a pop-up prompt to confirm you are sure is flagged as well as potentially capturing a note as to a reason.
New UI Enhancements/ Feature Request
Being able to select several alerts at once and from the Actions menu have disable/enable alerting available, preferable as a cycle alerting option so that it disables and enables automatically, that we can allow anyone to perform. As we often set SDT and need to clear the alerts in CSM, in order to achieve this we select disable then enable on each alert individually when there is over 100 alerts this can be a pain.
