jamiemurphyit
Joined 9 years ago
User Profile
User Widgets
Contributions
Datapoint - Metric type - counter - without "rate/sec math"
I would like to request an option when saving a datapoint of not having rate/sec math on counters / derive type datapoints. I have multiple custom datasources where I am trying to store the difference between two polls but the rate/sec math messes with this.16Views1like3CommentsRe: custom speed for interfaces
On 04/01/2018 at 11:00 PM, Steve Francis said: Now we support setting instance level properties through the UI (from the Info Tab for any instance via the Manage icon on the custom properties table), we can solve setting custom speed for interfaces. Setting an instance level property ActualSpeed and/or ActualSpeedUpstream (if different from downstream - if ActualSpeedUpstream is not set, and ActualSpeed is set, ActualSpeed will be used for both upstream and downstream) will override the Speed and BasicSpeed values, used for interface utilization calculation. Another change - Speed and BasicSpeed are now set as discovered ILPs, rather than unchanging datapoints that were collected every collection cycle (minor efficiency gain). Can you give some examples of what ActualSpeed should be set to? Is it bits? bytes?44Views0likes0CommentsDo no run autodiscovery on devices in SDT
We have had the issue where we are performing maintenance and temporary setups have been autodiscovered that should not have been which start alerting once SDT on the device has finished. EG temporary online network ports getting monitored and some https interfaces that are normally disabled getting monitored because they were enabled during maintenance and auto discovery found them10Views1like2CommentsUTC Timezone - No Country labeling
I would like to be able to set our account to UTC. Right now we use UTC+-0 Dublin. This causes some users to think this is the dublin timezone (for 6 months of the year with DST that is correct. for the other six months it causes confusion). When set to the current UTC 0 Dublin setting alerts then show GMT in their date time string :-/ Can we please get an option for UTC with no mention of countrys / Citys or GMT?5Views1like1CommentRe: CDP Neighbors DataSource
@David Bond (LM) I wrote something like this a year ago with a slightly bigger ambition. It pulls the list of CDP neighbours but then on the 10 minute poll it runs a groovy script to check if the CDP neighbour exists in LM and sets off a warning if not. This made it much easier to find unmonitored devices28Views0likes0CommentsRe: Radius authentication monitoring?
Actually have this issue myself. Working around it by using radtest on a linux collector and dropping to cli with expect commands to execute the radtest commands. On the note of ISE have you found any good snmp OID's to poll for ISE specific health?84Views0likes0Comments