Forum Discussion

Strebowski's avatar
Strebowski
5 years ago

Monitoring Bandwidth Utilization - Firepower FTD's

I'm trying to figure out how to monitor the bandwidth utilization on two FTD's we have in LogicMonitor. The interfaces that get polled via SNMP primarily shows a Gigabit NIC followed by some tap in...
muiz's avatar
muiz
5 years ago

 

I think you'd have to enable and configure SNMP under 'Devices > platform settings' as well in Cisco FMC and then add the firewall/Lina module of FTD separately in LogicMonitor using inside/outside IP of FTD.

That should then show all interfaces as they normally show up on ASAs.