Forum Discussion

Strebowski's avatar
4 years ago

Monitoring Bandwidth Utilization - Firepower FTD's

I'm trying to figure out how to monitor the bandwidth utilization on two FTD's we have in LogicMonitor. The interfaces that get polled via SNMP primarily shows a Gigabit NIC followed by some tap interfaces such as tap0 & tap0.1. The interfaces don't line up with what we're seeing in the Firepower Management Center GUI. Does anyone have any ideas as to how this could be monitored? 

1 Reply


    I think you'd have to enable and configure SNMP under 'Devices > platform settings' as well in Cisco FMC and then add the firewall/Lina module of FTD separately in LogicMonitor using inside/outside IP of FTD.

    That should then show all interfaces as they normally show up on ASAs.