Automated RBL Check

1 minute ago, mnagel said:

I cannot attach it here, but please copy from the link below (will need to setup keybase, but if you haven't, you should :)).

keybase://public/ciscoqid/LogicMonitor/RBLCheckMulti-.xml

It is still entirely done, but it is working. I need to add some documentation and tune it a bit.  For this, I set applies to on all collectors, then you use the "Add Monitored Instance" on whichever collectors you want.  The instances should have the hostname and IP as name and wildvalue, respectively.  I did not code support (yet) for using a FQDN as the wildvalue, just IP.

Thank you very much. Not sure the service I was using supported hostname. It specifically says IP address on the site.